3-4
7.
To remove the core board:
a) Remove the wire connectors from P1,
P2, P3, P5, P6, and P7.
b) Unclip the tabs at the top of the board,
and remove the shield and board from
the dispenser housing.
NOTE:
If the
tabs become damaged, secure the
board with two screws at the indicated
top corner locations.
P6
P7
P5
P1
P2
P3
b) Press in on the release button, and slide
the pad switch clips off the dispenser
cover assembly.
Back Of Dispenser
Cover Assembly
Water & Ice Pad
Switch Connectors
8.
To remove an ice or water pad switch:
a) With the back of the dispenser cover
assembly facing up, press the release
tab in on the wire connector, and pull the
connector off the user interface board
pins.
c) Remove the pad switch assembly.
Slide Pad Switch Up
To Disengage Clips
Pad Switch
Assembly
Screw Hole
Release
Buttons
Water
Ice
Core Board
Board Orientation Notch
Screw Hole
Core Board Tabs
Содержание 8178501A
