Panel F
When moving the
washer/dryer...
• Disconnect the power supply cord,
then tape securely to the
washer/dryer.
• Shut off the gas supply valve in the gas
supply line.
• Disconnect the flexible gas connector
and fittings from gas supply line and
cap the gas supply line.
• Tape the flexible gas connector to
back panel of the washer/dryer. DO
NOT DISCONNECT THE FLEXIBLE GAS
CONNECTOR FROM THE
WASHER/DRYER.
• Unscrew the cable bracket from the
wall stud or concrete wall. Save the
bracket and four screws.
• Tape the drum to the front panel. Tape
the lint screen in place. Tape the dryer
door closed.
• Wedge a blanket between the tub ring
and cabinet top to restrict tub
movement.
Before installing the washer/dryer in your
new home, check with your gas supplier
or dealer to see that your dryer is
equipped with the correct burner for the
particular type of gas in your new home.
Burner information may be found on the
rating plate in the door well of the dryer.
If washer/dryer does
not operate properly...
Check the following to be sure that:
1. Electric supply is connected.
2. House fuse or circuit breaker is intact
and tight.
3. Washer lid or dryer door is closed.
4. Controls are set in a running or “ON”
position.
5. Dryer start button has been firmly
pushed.
6. Make sure shipping strap has been
completely removed and was used to
secure the drain hose to the tub or
standpipe.
7. Gas shutoff valve is open in supply line.
If you need
assistance...
The Whirlpool Customer Interaction
Center will answer any questions about
operating or maintaining your
washer/dryer not covered in the
Installation Instructions. The Whirlpool
Customer Interaction Center is open
24 hours a day, 7 days a week. Just dial
1-800-253-1301 — the call is free.
When you call, you will need the
washer/dryer model number and serial
number. Both numbers can be found on
the model/serial rating plate located in
the door well behind the dryer door and
on front of opening.
If you need service...
In the event that your Whirlpool
appliance should need service, call the
dealer from whom you purchased the
appliance or a Whirlpool-designated
service company. A Whirlpool-
designated service company is listed in
the Yellow Pages of your telephone
directory under “Appliances —
Household — Major — Service or Repair.”
You can also obtain the service
company’s name and telephone
number by dialing, free, within the
continental United States, the Whirlpool
Customer Interaction Center telephone
number, 1-800-253-1301. A special
operator will tell you the name and
number of your nearest Whirlpool-
designated service company.
Maintain the quality built into your
Whirlpool appliance — call a Whirlpool-
designated service company.
1" x 4" x 24"
mounting board
secured across
two wall studs or
on a concrete
wall.
Four screws
secure cable
bracket to
mounting
board.
The exhaust
requirements, cable
requirements and
wiring diagram are
located on the back
of the access panel.
