3-9
Cooking Products Service Manual
Original April, 1996
4321972
© 1996 Whirlpool Corporation
Page 3-9
NOTE: If you are replacing an element, per-
form steps 5 and 6. If you are replacing just a
limiter, proceed to step 7.
5.
With the wires connected to the termi-
nals, lift the old element out of the base,
and install the new one in its place with
the terminals positioned the same as the
old one.
6.
One at a time, disconnect the wires from
the terminals of the old element, and re-
connect them to the same terminal loca-
tions on the new one.
7.
Lift the element with the defective limiter
so you can access the bottom, and re-
move the screws from the old limiter, then
pull the sensing tube out of the element,
and remove the limiter.
LIMITER
ELEMENT
SENSOR TUBE