Wheel Horse 867, Руководство пользователя

Страница: 3 / 12

The clutch pedal 0150 operates the brakes WHEN
DEPRESSED ALL T HE WAY DOWN. For this reason, you
should depress the clui(.h pedal ONLY
%
OF THE WAY
DOWN WHEN
SHIFTING while in motio�. This clutc
�
.
broke pedal combination makes clutching automatic
05 you apply the brakes to 5tOp. See Figure I.
fiGURE I
PARKING BRAKE
The pa rk ing brake is located on the left side. of
the tractor 0$ 5hown in figure II.
To set the parking
broke depress the dutch-brake pedal as for as pos­
sible and push the parking brake down. To relea$e
the brake depress the clutch-broke pedal.
BRAKE ADJUSTMENT
The brake bond, located on the left side of the
transmISSIon, brakes the transmission and in turn
stops the wheels.
To adjust. depress dutch brake pedal and move
parking brake lever forward into the engaged posi­
tion. Tighten nut on brake rod until both rear wheels
skid when tr<:lctor is pushed - parking broke en­
gaged. Tighten nut another Yt tur�. The broke. and
parking brake are now properly adrusted. See Fig. II.
, fiGURE
H
3
LIFT HANDLE
The lift handle is used to lift or lower equipment
used with the tractor. Depress the release button to
lower the handle.
When the equipment is allowed to float, the for­
w ar
d
travel of the handle can be limited by the
adjustable stop. Turn the hand knob till the stop
reaches
the
desired position.
ATTACHING
TOOLS
Complete information on the assembly, attachment,
operation and service of the many attaching tools will
be provided with each attachment.
CARE OF TRACTOR
1. Keep tractor greased and oiled regularly. Re­
fer to Figure III or the local ion of grease fittings. Check
transmission and engine case oil levels.
2. Keep engine air deaner clean. This will add
'
to engine life.
3. Keep tires properly inflated. See previous
in­
structions.
4. Keep trador covered <:Ind in <:I dry place when
not in use.
5. Keep grass and dirt out of engine cowling 0$
Ihelle will stop the flow of air and decrease en­
gine
life.
6. LIGHTS. To replace light bulbs remove the
four screws holding the l
e
ns
,
push down and rotate
the bulb to the left, it will then come out. Replace
with ;#:1156 bulb. Ihe lights may go off when the
hood is raised, this is because it loses ground contact.
7. CLUTCH-BRAKE PEDAL ADJUSTMENT, The
dutch-brake' pedal rod may be turned in or out to
adjust the pedal to operotor's desired position. Re·
move pin from rod and turn rod in or out for' adjust­
ment. There are also
twa holes in the pedal to adjust
for travel. The upper hole is for
Q
short movement
of travel, the lower hole is for a long movement .
S. When replacing belts or mounting drive im­
plements make sure all pulleys ar& In line.
9. BATIfRY.
Check
electrolyte level periodically.
If tractor has been in storage it may be necessary to
recharge.
10. Your tractor is only as good as the service
you give it. See your Wheel Horse Dealer for a
thorough check-up after each season of use.
11. When replacing belts be sure to purchase gen­
uine Wheel Horse belts, as these belts are specifically
designed for each application.
(NOTE:
Make sure all pulleys are in line.)
12. To raise seat/fender unit pull knob back. See
Fig. Ill. Seat should be latched before operating tractor.
www.MyWheelHorse.com