Wheatstone D-8000, Техническое руководство

Страница: 65 / 169

page 8 – 5
D-8000 / Jan 2003
C P U & D S P M O D U L E S
5. The fifth function is serial interface control. The front panel of the
CPU module has a large pushbutton switch. Activating this switch will
enable the remote serial interface to the console (REMOTE), and de-
activating the switch will disable the remote serial interface. When the
interface is activated, any device connected to the interface can control any
of the console functions. Note that the console operator also has control of
the console functions even when the remote serial interface is enabled.; the
console will respond to any command regardless of where it comes from.
When the interface is disabled (LOCAL), the console will not respond to
any commands sent to the remote serial interface; it will respond only to
the console switches and faders.
The D-8000 console with the CPU-8S module has three additional
functions.
1. The first additional function is the console’s send controls. Sends
(SEND 1 and SEND 2) are used to provide special effect feeds or custom
monitor mixes to specific locations. The SEND controls work in conjuction
with DSP equipped input modules. For example, press the SET button on
an INDM-8. Then press the SEND1 ON button and rotate the SEND 1
control clockwise. The LEDs surrounding the SEND 1 control give an
indication of the level of the post fader post on/off signal from the chosen
INDM-8 that will feed the SEND 1 output (located in the OMD-8
MASTER C module). Press the PRE FDR button to take a pre fader signal
from the INDM-8. The PRE ON button provides a pre on/off signal.
SEND 2 works in a similar manner.
If SET is pressed on an input module that has already been assigned to
a SEND, the controls for that SEND will light to indicate the settings of that
input in the SEND output. Modules may be assigned to one or both sends,
or to neither send, as desired.
Two CUE switches (one for each SEND) place the send signals on the
console’s stereo cue bus where it may be heard on the meterbridge
mounted cue speakers and/or as an interrupt to the console operator’s
headphones and control room monitor speakers. The various cue interrupt
modes are programmed at the console’s CRD-8 (Control Room) module
via internal PCB-mounted dipswitches.
2. The second additional function is console’s preset security level. A
three digit password is entered to change the security level. Hold in the
SEND1 knob and turn the PRESET SELECT knob to indicate the desired
first digit of the password (0-9). Press the TAKE button to accept this first
digit, then turn PRESET SELECT again to dial up the second digit. Use
TAKE to accept the second digit, turn PRESET SELECT again to the
desired value of digit three, and press TAKE one more time. The security
level will change to that granted by the password so entered.
Note that the three digit password code can be changed from the VDIP
application. See the VDIP section for details.
D-8000 / Jan 2004