Wheatstone Corporation E-6, Техническое руководство

Страница: 50 / 111

page 3 – 24
E-6 / Dec 2007
M A S T E R P A N E L
Make sure USE DEFAULTS is NO if you want this signal to work differently than
the default settings, and then simply check the functions for this signal. If USE
DEFAULTS is set to YES, that signal will use the default settings. Once you have
the settings you want, click APPLY.
To load other signals you want to to change the settings of, press and hold an-
other fader’s A/B button or click the SIGNAL button and choose which signal to
load from the Signal List.
Click DEFAULT to change settings you want to be the same for ALL signals
The default settings form then shows the default values used for any signal unless
specifically overridden. If you have made changes and then decided you don’t
want to put the changes into effect, click RESET. This will cancel any changes
you made since entering the screen or since clicking APPLY, whichever happened
most recently.
PFL/CUE Dropout —When a channel’s CUE button is pressed it will assign the
channel’s signal to the CUE bus. When “PFL/CUE Dropout” is checked it causes
the channel’s CUE function to be de-activated whenever the channel ON switch
is pressed.
EFS—This function causes the channel to be OFF when the fader is fully down or
ON when the fader is brought up from the fully down position. The ON and OFF
switches can still control the channel.
Fader Cue—Assigns the signal to the Cue bus when the fader is moved all the way
down. The CUE button can still be used to change the CUE status.
PGM D Pre Fader—When checked, causes the signal, when assigned to the sur-
face’s PGM D output, to be tapped before the fader.
PGM D Pre On —When checked, causes the signal, when assigned to the surface’s
PGM D output, to be tapped before the channel ON switch.
Timer Restart —The surface’s digital timer can be programmed to automatically
reset to zero and begin counting up when the channel’s ON button is pressed. To
enable this function the AUTO button in the timer section of the Monitor Panel
has to be activated.
Machine Start Pulsed—When a signal is assigned to a fader, turning the fader on
generates a Machine Start logic that can be used to start a machine, such as a CD
player. This signal is normally active while the fader is on and is deactivated when
the fader is turned back off. But if “Machine Start Pulsed” is checked, the logic is
activated when the fader is first turned on, and then deactivates a brief time (roughly
one half second) later. This is useful for remote starting machines that do not like
to have a constant activation of their start input.
Remote Ready —The channel’s OFF switch normally has its LED indicator
controlled by the switch itself. This is the factory default setting. When “Remote
Ready” is checked, the channel’s OFF switch LED can be controlled by an external
source machine. This requires additional configuration in XPoint or Navigator to
fully implement the feature.
PGM D Off Line —This function determines what will be heard at the fader’s
Bus Minus output when the fader is off. If the box is not checked, when the fader
is off the same bus will feed the bus minus that feeds it when the fader is on, as
determined by the BUS MINUS SOURCE selection below. But if the PGM D Off
E-6 / July 2012