Wheatstone Corporation E-6, Техническое руководство

Страница: 32 / 111

page 3 – 6
E-6 / Dec 2007
M A S T E R P A N E L
Multi-Function Aux Knobs
When a fader strip is selected by pressing and holding A/B, the panel knobs set the
Aux Send level to the Aux bus. When no A/B buttons are active, these knobs act as Aux
Bus Master level controls.
Pressing the Aux/MixMinus Tab
switches the FUNCTION PANE to the
AUX and MIX-MINUS MASTERS screen
with four AUX master level controls and
ON buttons. If no channel A/B buttons
are active, the physical AUX Send Knobs
adjust the Master Aux Send output levels.
TB (Talkback)
To interrupt an AUX bus signal with the surface’s predefined TB
signal, press the TB switch for the desired AUX 1 - AUX 4 send. This
allows the control surface operator to communicate with the Talent or
location receiving that AUX send.
Note that the Talkback source, typically a host mic, must first be cross
connected to the surface’s TB input using either XPoint or Navigator
software, or the E-6’s built in Route function. The TB signal may be
any Source signal in the router including MXM or Aux busses. The
E-6’s TB input signal is a factory defined surface Destination signal
(greater than ID1001) with a name similar to E1TBk. The actual signal
ID number and signal name depend on how many surfaces you have.
E-6 / July 2012