WHD TUBULAR BELLS, Руководство по установке

Страница: 4 / 6

4
5. Damper box assembly: loosen the screws from
both left and right of the damper box, raise it
up and insert both supporting rods through the
holes on the left and right of the damper box.
Put it down slowly. Try to avoid sliding friction to
the supporting rod.
7. Accessory kit assembly: loosen the butterfly nut
and mount it on the left supporting rod, tighten
the butterfly nut.
8. Tube hanging device assembly: loosen the screws
on the tube hanging device. Raise it up, mount it
to the supporting rod by inserting the rod into the
holes on the device. Put it down slowly, the tube
hanging device should be parallel to the damper
box, as in the picture below.
6. Damper pull rod assembly: insert the damper
pull rod straight end into the pedal device pull
rod hole. Hang the curved end to dampen the
box damper board, tighten the nut properly.
ATTENTION!
Secure the pedal in place by ensuring all the
screws are tight.