Manual AMP 4200
Valid for
111-425-04-001-00
Version (modifications reseverd)
21.02.2022
Seite 15 of 17
10.3. Manual configuration
The device can also be configured using the buttons and controls on the front.
We deliver each device with a personalized configuration so that you can do without the configuration
using the device buttons.
We have mentioned the necessary manual steps for operation below.
(1)
(2 … 5) (6) (7) (8)
1 … ON/OFF button
2...5 Output channel (CH1/A, CH2/B, CH3/C, CH4/D)
6 … Display
7 … „BACK“ botton
8 … „ADJUST/SET“ (selection key, right / left rotation, push)
Note:
If no button is pressed, the device jumps back after approx. 60 seconds and takes over the current
settings.
10.3.1. Retrieve the current IP address
Press the ADJUST / SET button (8) and turn it one step to the left.
"Device Info" appears in the display.
Press the ADJUST / SET button (8) again.
The current IP address of the device appears.
If you do not press / turn a button for approx. 60 seconds, the device jumps back to the original
indication on the display. You can return at any time by pressing the "BACK" button.
10.3.2. Manual volume adjustment via the device buttons / buttons
Press the button of the desired output channel (2… 5).
The preset volume value (attenuation, -XY, Z dB) now appears on the display.
Turn the ADJUST / SET knob (8) to the left (quieter) or to the right (louder).
If you do not press / turn a button for approx. 60 seconds, the device jumps back to the original
indication on the display. You can return at any time by pressing the "BACK" button.
