Wharfedale Pro R1604, Руководство по эксплуатации

Страница: 8 / 16

25. The SOLO ON indicator
,
This LED lights up when any of the channels are SOLO d, indicating that the Left meter are now
functioning as SOLO meter.
26. Power ON LED: This LED is illuminated when Power is ON.
27. Phantom Power switch: Press this switch applies 48 volt phantom power to all the microphone inputs.
Phantom power should be turned off when not required, and must never be used with an unbalanced
microphone. Do not operate this switch with the fader up, as a loud click will result.
28. Phantom Power LED: When this LED is illuminated it indicates that the +48 V DC Phantom Power is
present.
2Track In/Out
29. 2 Track Input: The two track input section has RCA jack inputs to enable easy connection to a DAT tape
devices, or a cassette and other audio equipment. This is used primarily for listening to mix playback
from a tape for example.
30. 2 TK to MIX: Press this button allows you to monitor the output from the two track tape machine
connected to the Stereo 2 Track inputs. The signal from the tape is fed in to the Main mix.
31. 2 TK to CONTROL ROOM AND PHONES: Press this button allows you to monitor the output from the
two track tape machine connected to the Stereo 2 Track inputs. The signal from the tape is fed in to the
CONTROL ROOM and PHONES.
Control Room/Phones
32. Control Room Output Jacks: The control room output is normally connected to the monitoring system
in the control room and carries the stereo MAIN mix or, when selected, the SOLO signals.
,,
33. Headphones: This is unbalanced on a 1/4 stereo jack. Cables connected to this output should be
wired with TIP left signal, RING right signal, and SLEEVE to ground. Use only stereo headphones! Use
mono headphones may cause damage!
34. Control Room Level control: This knob controls the levels of both the stereo control room and phones
outputs.
35. MAIN MIX and ALT 3-4 switch: Press these buttons allow you to monitor the signal from the Main Mix or
ALT 3-4.
Main and ALT 3-4 Level
36. Main Mix Faders: These control the overall level of any signals which have been sent to the stereo
left and right outputs on the back section.
37. ALT 3-4 fader: This fader controls the overall level of any signals which have been sent to the ALT 3-4.
38. ALT 3-4 TO MIX: Press this button allows you to send ALT 3-4 signal to the Main Mix outputs.
R1604 & R2004
R Series Mixers
.7.