1 4
图3
●
Settings
Press the MENU key to boot into the "System
Settings" menu,use Up / Down arrow keys to
select the "trainer / Simulator", press OK key to
enter the function interface, as shown above. The
steps of setting is as follows:
1, first to use the up / down arrow keys to edit the
selected item.
2. Press OK button to confirm, then press the right
arrow keys to determine. Reboot to take effect.
4.Control Stick Settings
●
Function
●
Settings
Control stick settings function allows users
to freely setting the higher of the stick according
to personal preferences . As shown. This machine
Totally have four models to be chose .
Press the MENU key to boot into the "System
Settings" menu,use Up / Down keys
to select the "stick settings" and press OK key to
enter this function interface, as shown above
The steps of settings is as follows:
1. First to use the arrow keys to select the edited
item .
2 Use Up / Down key to implement Stick Mode .
3. Set successfully, press EXIT key to exit.
5.
Stick Calibration
Joystick calibration function allows users to
change the throttle side according to personal
preferences .
●
Function
●
Settings
Press the MENU key to boot into the "System
Settings" menu , use Up / Down keys to select
"Stick calibration" and press OK key to enter the
function interface, as Shown above. Specific
settings, follow these steps: 1.First to use the arrow
keys to select the edited item, (aileron calibration as
example ). 2.Put the calibrate joystick placed in the
midpoint of the channel position, options Up / Down -
key implement the control calibration . 3.Selection into
the Figure 3. When the "middle" lights, press OK key
(this time the Point calibrated is OK), into the
stickmaximum (high) calibration. 4.When the "high"
lights, put the stick gently leaned on the right (throttle
/elevator on the top edge, aileron / rudder on the right
edge), press the OK key (in this case the maximum value
has been calibrated), into the stick minimum (low)
calibration. 5.When the "low" lights, put the stick gently
leaned on the left (throttle / elevator on the lowest,
Aileron / rudder on the left edge), press the OK key (while
the stick minimum calibrated OK). 6.At this memont the
bottom of the screen displays "confirmation / reset" and
press to OK key ,all the calibration is completed,
automatically return to the superior menu, use the
arrow key selects to re-enter Calibration
Procedures.
1---ileron
2---evator
3---hrottle
4---Rudder
Helicopter Functions
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE
