Wezag WDT UP 14 ZLW, Руководство по эксплуатации

Страница: 43 / 51

BDA UP 14 ZLW
– 4481N16000 – 09/16 – REV. C
Page 43 / 51
Crimp process with locator:
1. Swing out locator away from die set.
2. Insert the crimp contact in the die locator. Please pay attention to the correct profile
assignment and to the correct positioning within the crimp profile!
3. Swing locator with contact inserted back towards die set.
4. Insert the wire/cable, which is stripped acc. to the specifications, and position it for
crimping.
5. Press the foot pedal to start the crimp process.
6. Keep the foot pedal pressed until the crimp cycle is finished.
7. Unlock locator and remove crimped contact.
9 Maintenance
DANGER
+
Due to the risk of hand or finger injury, never try to reach into the machine before having
assured that the machine is disconnected from the air supply. Disconnect the air supply
before changing the safety guard and the dies.
CAUTION
+
The compressed air connection tube must not be longer than 1 m and has to have a
coupling connection.
+
Before starting maintenance, disassembly or repair work, the crimp machine must be
disconnected from air supply.
+
Maintenance work may be performed only by authorized and properly trained staff. The
housing and the covers in particular may only be removed by specially trained staff.
+
When working with the pneumatic Crimp Machine UP 14 ZLW, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the pneumatic Crimp Machine UP 14
ZLW.
+
The crimp machine is only allowed to be used when it is in complete functional condition.
+
The crimp machine is only allowed to be used with mounted dies and safety guard.
+
Work with caution.
+
Only one person is allowed to work on or with the machine at a time.
+
Assure free access to the operating elements of the machine, especially the foot pedal and
the release button. In case of imminent danger press the release button immediately. The
release button must be within the direct reach of the operator. It must not be covered.
+
It is only allowed to work with the specified air pressure.