29
WWW.WETJETPOWER.COM
6. Uncoil high pressure hose and attach quick connect end of hose to the base of the
spray gun. Pull down on collar of quick connect, slide onto spray gun and let go of col-
lar. Tug on hose to ensure the connection is tight and secure. If the connection is even
slightly loose, disconnect and try again.
4. Attach wand extension to spray gun. Tighten by hand. Please note that wand ap-
pearance may differ based on pressure washer model.
5. Choose desired spray tip, pull back nozzle extension collar, insert spray tip and
release collar. Tug on spray tip to make sure it is securely in place. See
Spray Tips
for information on each type
.
NOTICE
DO NOT run the pump without the water supply connected and turned on.
•
Damage to equipment resulting from failure to follow this instruction
will void warranty.
How to Start Your Electric Pressure Washer
To start your pressure washer for the first time, follow these instructions step-by-step.
This starting information also applies if you have let the pressure washer sit idle for at
least a day.
1. Place pressure washer near an outdoor water source capable of supplying water at
a flow rate greater than 3.8 gallons per minute and no less than 20 PSI at the end of
the garden hose. DO NOT siphon supply water.
2.
Ensure unit is level and placed on a flat, even surface.
3. Connect garden hose to water inlet on pressure washer pump.
WARNING
To reduce the risk of electrocution, keep all connections dry
and off the ground. Do not touch plug with wet hands
STARTING YOUR ELECTRIC WASHER