16
Set-up and Operation
AUTO
Position for normal operation of unit;
OFF
Position for storing, shipping and
non-use for extended period of time,
position for initial 3-day charge. In
this position the battery is charged
but the light does not turn on.
5. Leave the switch in the OFF position for at least 3 sunny days.
6. After the initial charge, set the switch to the
AUTO
position.
Note:
If the LED lamp flashes in regular intervals, the batteries
are empty. Expose the solar module to direct sunlight in order to
recharge the batteries.
Adjusting the Motion Sensor
There are three adjusting knobs on the motion sensor: TIME,
SENS and LUX.
TIME
–
Illumination Time:
Setup how long the unit stays lit after motion stops in the field of
vision of the motion sensor. The time can be set from 10 seconds
to 1 minute. Please note, once the light has been triggered by the
sensor any subsequent detection will start the timed period again
from the beginning.
SENS
–
Sensitivity Adjustment:
The sensitivity of the motion sensor will be affected by the
ambient temperature. The higher the temperature (e.g. in the
summer), the higher the sensitivity setting of the motion sensor
must be set
in order to “detect” motion within the field of vision.
So you can adjust the SENS knob to compensate the change of
sensitivity affected by the ambient temperature.
LUX
–
Lux Control Level/Ambient Light Adjustment:
The lux control module has a built-in sensing device (photocell)
