FEATURES
Marine Compliant
Rubber gasket covering crossover controls designed to keep moisture away.
Conformal coated pcb for protection against moisture. Completely sealed design
for no water intrusion.
Built In Raised Feet
The sinister amplifiers were designed with integrated raised side feet. This gives
easy access to pull wire under the amplifier. This also raises the amplifier off the
boats panel or carpet allowing air to circulate.
POWER CONNECTIONS
To gain access to all connections, first remove the 4 2.5mm Allen head screws
and remove the top cover. The top cover can be replaced after all connections and
adjustments are complete.
The Sinister SDX2500 is designed for 1/0 AWG Power wire (+12 V) and Ground
wire (GND). You will need to prepare the wire by remove 5/8” on the protective
shielding on the power and ground wire. Then take a Phillips head tool and back
out the screws on the terminal block +12 volt wire into the +12V side of the terminal
block and then tighten the screw back into the terminal block. You will do the same
for the Ground wire. Please make sure you are using “positive” wire for the +12V.
Also, please make sure you are running the ground back to the battery when used
in a marine application. (in a car audio application, make sure to ground to the
chassis as close to the amp as possible). You will also be attaching the Remote
turn on. Labeled Turn ON” This is usually a blue wire from the head unit.
6
Wet Sounds Sinister SDX 2500 Owner’s Manual
