9
Wet Sounds Sinister SDX 2500 Owner’s Manual
SDX2500 Dimensions
SDX2500 Front Plate
SDX2500 Control
22.125”
10.25”
3.0”
SDX2500 Dimensions
SDX2500 Front Plate
SDX2500 Control
22.125”
10.25”
3.0”
MASTER/SLAVE CONFIGURATION/CONTROL SETTINGS
Left/Right Input
From Source.
Speaker outputs - 1 Ohm Minimum
Single RCA cable from “Slave Out”
to “Slave In” of next amp.
Single RCA cable from
“Slave Out” of 1st Amp to
“Slave In” of 2nd Amp.
Use only “Master”
remote level control.
do not use
The SDX 2500 is equipped with a Master/Slave Circuit. This allows control of 2 or
more amplifiers from 1 set of controls. All gains, crossover, bass boost, subsonic
filter, and remote level will be controlled from a single “Master” SDX 2500 Amplifier.
This eliminates gain/crossover matching normally needed when using multiple
amplifiers.
Master/Slave Control Settings
Use only the Crossover, Subsonic, Bass Boost, & Gain controls of the “Master”
amp. These controls will not respond on any other “Slave” amp in the chain.
Set “Phase Control” on all amps to “IN”.
Set “Master” amp to “Normal”. All
other amps in the chain set to “Slave”.
SDX2500 Dimensions
SDX2500 Front Plate
SDX2500 Control
22.125”
10.25”
3.0”
