General Safety Information
• This inverter must be connected only to a 12 volt DC
Negative Ground ignition system (most vehicles). Do
not use this inverter with Positive Ground vehicle
ignition system. Consult your vehicle owner’s manual
for ignition system identification.
• Do not use this inverter with device which use more
than 800 watt power consumption. Make certain the
wattage requirements are within the capacity of this
inverter output watt range.
• Do not connect inverter to household or RV, AC
distributing circuit. Do not connect inverter to AC load
circuit in which the neutral wire is connected to ground
(-) or to negative of the DC battery power source.
• Do not connect to a 6 volt or 24 volt DC battery.
• Do not use an AC (115 volt) extension cord longer
than 25 feet.
• Do not use a 12 volt DC extension cord of any type
or length.
• Start and run your vehicle hourly to prevent battery
discharge. IMPORTANT: Power OFF the inverter and
device(s) being used before engine start up.
• Improper use of this inverter can cause personal
injury, property damage, and/or possible loss of life.
• Do not use or place this inverter near flammable
materials or any location which accumulates
flammable fumes.
• Do not operate this inverter in or near water. Do not
operate inverter using wet hands.
• Do NOT touch tip of the inverter 12 Volt plug
immediately after usage. The plug may be hot and
could cause minor burns.
• Disconnect power to the inverter when it is not in use.
• To avoid potential property damage, do not leave this
inverter or any device operating unattended in vehicle.
• Do not place this inverter in confined spaces or
inside battery compartment of vehicle or boat. Use
only in properly ventilated areas.
• Do not place item(s) over the inverter. Make sure that
air is allowed to circulate freely around it.
• Do not place the inverter in direct sunlight or near any
device which is generating heat above room temperature.
• Do not operate inverter in ambient air temperature
below -10°F or above 110°F.
• Regularly check that all connections are secure and
tight. A loose connection can create high electrical
resistance and generate excessive heat which will
damage the inverter.
• Not approved for use in conjunction with medical
equipment.
• Reverse polarity connection will damage the inverter
and possibly any connected equipment.
• Do not open the inverter housing case.
• Secure the inverter and device being operated to
prevent them from moving while the vehicle is in motion.
• This is not a toy. Keep out of reach of children!
NOTE:
To achieve maximum inverter power output, user
must run vehicle while inverter is in use.
• Keep this instructions for future reference.
• Start and run your vehicle hourly to prevent battery
discharge.
Installation
WARNING: Explosive GAS DANGER! Only make battery
and ground connections in a well ventilated area.
1. Prior to connecting inverter, make sure the
inverter ON/OFF rocker switch is in the OFF
position.
2. Attach the open-ring type connector (RED CABLE) to
inverter RED (+) input TERMINAL.
3. Attach the open-ring type connector (BLACK CABLE) to
inverter BLACK (-) input TERMINAL.
4. Hand tighten both terminal nuts securely. Do not
over-tighten.
5. Connect the RED alligator clip to the vehicle battery
positive (+) terminal.
6. Connect the BLACK alligator clip to the vehicle chassis,
engine block or a non-moving grounded metal part of
vehicle as far away from the battery as possible.
System normal operation ............. Green LED Indicator
Over voltage ................................. Red LED Indicator
Over load...................................... Red LED Indicator
Low battery................................... Red LED Indicator
WARNING
CAUTION
Operating Instructions and Parts Manual
1YAY6
800 Watt
Power Inverter
ON
OFF
Black Alligator Clip
to Chassis Ground
800 Watt Inverter
Vehicle
Battery
Red
Alligator
Clip
Black
Alligator
Clip
Black Input
Terminal
Red Input
Terminal
Black Cable
Red Cable
Positive (+) Terminal
