- 7 -
- Never use the tool without the PRCD delivered with the tool.
- Replacement of the plug or the supply cord shall always be carried out by the manufacturer of the
tool or his service organization,
- Keep water clear off the electrical parts of the tool and away from persons in the working area.
TRANSPORTATION
Before transportation, first to lock the cut unit by the lock system.
This machine is equipped with one set of wheel systems
for one person transports it easily from car
to job site and for mobility
once on the job site. Please refer to part of Moving the saw.
Note: Before moving the saw, the water should be drained out of the water tray.
Ⅲ
SPECIFIC SAFETY RULES
●
Ensure that the directional arrow marked on the diamond blade corresponds with the rotational
direction of the motor.
●
With the machine disconnected from the power supply, rotate the diamond blade by hand to ensure
it is free from obstruction.
●
Always keep the blade-securing arbor and collars clean.
●
Ensure that the blade-securing bolt is securely tightened.
●
Never try to cut freehand. Always ensure that the tile to be cut is pressed firmly against the rip
fence.
●
Ensure that the work piece that will be cut off has sufficient room to move sideways. Failure to do
so may result in the off-cut binding against the blade.
●
Never cut more than one tile at a time.
●
Never cut pieces too small to be held securely against the rip fence without leaving enough space
for the hand to be a safe distance from the diamond blade.
●
Ensure that the table and surrounding area are clear with the exception of the tile to be cut.
●
Before cutting a tile piece, let the diamond blade run freely for a few seconds. If it makes an
unfamiliar sound or vibrates excessively, switch it off immediately and disconnect from the power
supply.
●
Let the diamond blade reach full speed before start cut.
●
Let the diamond blade come to a complete stop before removing any jammed or off cut material
from around the blade area.
●
Never allow the diamond blade to run dry. Failure to keep the water tray topped up will result in
possible over-heating of the diamond.
●
Do not expose to rain or moisture.
●
Wear suitable protective equipment.
Eye protection ear protection Caution, risk of cutting Hand protection
Shall be worn shall be worn shall be worn
Always ensure that the splitting wedge is correctly set for the work.
