- 10 -
folded machine. (Fig.3)
2.
Lay
the stand on level surface, stand it up according to procedures as shown in Fig.4 to Fig.9.
3.
To
stabilize stands by adjusting the leveling
“set screw” located on the bottom of right front leg.
(Fig.10).
4. Assemble the saw onto the stand and lock it (Fig.11.1). The saw stands up now.
5. Install the handle on cut unit by attached screws. The screws are attached on the mounting place.
6.
The
cut unit is locked into place by the lock under the slide rail during shipment. Unlock the cut unit
before cutting (Fig.11.2&11.3).
NOTE:
When not in use, always lock the cut unit to prevent it rolling back and forth along bridge.
Warning: Always lock the cut unit before any maintenance and transportation!
7.
For wider tile than the main table designed, the extension table should be pulled out to support the
tile., Fig.11.4.
Fig.3
Fig.4-folded stand
Fig.5-pull out right leg
Fig.6-Lock the right legit.
Fig.7- lifts up the frame and
unfold the left leg.
Fig.8-lock the left leg.
Fig.9-the stands stand up
Fig.10
Fig.11.1
Fig.11.2 unlock position
Fig.11.3 lock postion
Fig.11.4 extension table
