- 12 -
Fig.13-Making straight cut
Fig.14-Making angle cut
Fig.15
2.
Slide
the rip miter gauge against the tile and lock the gage by tightening the knob.
3.
Position
the tile firmly against the fence and rip/miter guide, slowly and smoothly pull blade
assembly handle towards you to begin cutting. DO NOT force the motor to cut too quickly. (Fig.13).
F. MAKING A MITRE CUT
1.
Loosen
the knob and position the rip/miter guide so that the correct angle you want, 0º to 45º, is
lined up with the notch. Tighten knob at that position.
2.
Align
the tile with rip/miter guide and hold firmly against guide. Turn on laser switch. Note that
laser will show cutting line. As in above straight cut, slowly and smoothly pull blade assembly handle
towards you to begin cutting. (Fig.14)
G. MAKING A BEVEL CUT
1. Loosen
the knobs located on each rail stand of stoner cutter (Fig.15).
2. Tilt
the bridge to the desired bevel angle 0º to 45º. Be sure to line up the bevel angle degree
markings on each of rail stand, it will be easier to detect the degree through transparent window.
3. Tighten
the knobs and follow directions above to make cut.
H. MOVING THE SAW
1.
Lift the machine and drag the wheels to make them stand against ground (Fig.11.5, 11.6, 11.7).
2.
Then raise the opposite end by handle to move the saw forward.
Note: While the machine is in use, make sure the wheels are hanged up to locked position Fig.
18.8.
Note: Before moving the saw, drain the water tray and lock the cut unit.
Fig.11.5
Fig.11.6
Fig.11.7
Fig.11.8
