CONTROL PANEL
• Best results are obtained by using a low speed for
normal conditions and a high speed when odours are
more concentrated.
• Turn the hood on for a few minutes before you
start cooking.
• The hood should be left on for a minimum of 5 minutes
after cooking or until all odours have dispersed.
• The control switches are located on the front panel of the
unit. See Fig. 19 below.
Fig. 19
A.
Filter
• This is the indicator/switch to show when the filter needs
to be cleaned .
• Once the filters are cleaned the “Filter” alert can be
deactivated with a single touch.
B.
Timer
Using the Timer
• At the end of cooking, if the timer is switched on, the
rangehood will continue to run for an additional 5 to15
minutes, depending on the selected fan speed .
• The fan speed is reduced in 5 minute increments until the
rangehood turns it self OFF.
• If the fan speed is set on high, it will run for 5 minutes
then reduce to medium for 5 minutes, then reduce to low
for 5 minutes bef ore finally turning it self OFF.
• This should ensure the removal of any odours that remain
after cooking.
C.
Lights
To switch Lights ON and OFF
• Touch the 'light' symbol to turn the lights ON, if adjustment
to light intensity is required continue to touch and hold
until required brightness is achieved .
• Touch 'light' symbol again to turn the lights OFF.
D.
Power on/off
E.
Fan speed 1-
light frying/boiling
F.
Fan speed 2-
frying/wok cooking/heavy boiling
G.
Fan speed 3-
grilling, intensive frying and wok
cooking
A
B
C
D
E
F
G
CARE & MAINTENENCE
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions
to ensure the best possible result is achieved without
damage.
CAUTION
Cleaning the hood
• Clean the outside of the hood using a damp cloth and
a solution of water and mild washing up liquid. Clean
stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure the best results also use an even pressure and
follow the grain of the stainless steel. Use of a soft cloth
reduces the risk of scratching. If the cloth is wet ensure
that a dry soft cloth is used to wipe down the surface
and apply stainless steel protector to reduce the risk of
any surface rust appearing.
• Never use corrosive, abrasive or flammable cleaning
products or products containing bleach.
• Never insert pointed objects in the motor’s
protective grid.
• Only ever clean the switch panel and filter grill using a
damp cloth and mild washing up liquid.
• It is extremely important to clean the unit and change the
filters at the recommended intervals. Failure to do so will
cause grease deposits that could cause a fire.
Removing the metal grease filters
• Push the grease filter towards the back of the unit and
then pull it down and out.
NOTE. This product is fitted with a safety cutout device.
If the cooker hood is installed to close to the cooktop, flambe cooking, operating the cooktop without cooking utensils and
blocked filters may activate the safety cutout device. If the hood stops during operation, correct the faults and allow time
for the safety cutout device to reset, the cooker hood will then function correctly.
11
