14
General installation
Connect the exhaust duct to the outside exhaust system (see
1.
pages 4 through 6). Use of a 4” (10.2 cm) clamp (item A) is
recommended to connect the dryer to the exhaust vent system.
Use metal foil tape to seal all other joints.
Carefully slide the dryer to its fi nal position. Adjust one or more of
2.
the legs until the dryer is resting solidly on all four legs. Place a level
on top of the dryer. The dryer MUST be level and resting solidly on
all four legs. Rock alternating corners to check for stability. Remove
and discard door tape.
Plug the power cord into a grounded outlet.
3.
Turn on the power at the circuit breaker/fuse box.
4.
Read the
5.
Use & Care Guide
provided with the dryer. It contains
valuable and helpful information that will save you time and
money.
If you have any questions during initial operation, please review
6.
the “Avoid Service Checklist” in your
Use & Care Guide
before
calling for service.
Place these instructions in a location near the dryer for future
7.
reference.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
A wiring diagram and technical data sheet are
located inside the dryer console.
A
Instructions to reverse the Dryer Door
IMPORTANT NOTES:
Read complete instructions before beginning.
•
Handle parts carefully to avoid scratches.
•
Place the screws next to the pieces where they will be
•
positioned to prevent them from being used in wrong
place.
The normal time to reverse the direction of dryer door
•
is 30-60 minutes.
IMPORTANT
•
: Once started, do not move the cabinet
until the procedure is complete.
TOOLS:
Phillips Screwdriver
PARS OF THE DOOR:
#8 SCREW S
(18x)
STRIKE PLATE
(no hole)
STRIKE PLATE
(with strike)
DOOR HINGE
(2x)
INSIDE PART OF DOOR
OUTSIDE PART OF DOOR
SCREW #8
(18 pieces)
PLATE
(no perforation)
SECURITY PLATE
(with perforation)
HINGE
(2 pieces)
SOLID DOOR
GLASS DOOR
PARTS OF THE DOOR:
INSIDE PART OF DOOR
OUTSIDE PART OF DOOR
Содержание MKRN13FWAWB
Страница 3: ......
