Westinghouse 61007, Инструкция по эксплуатации, Страница: 12 / 36

GS-26-JH01-WH21 12
GB
FIGURE 1.
D
B
M
A
E
H
F
C
G
T
I
1. Thread mounting screws (A) into the matching holes of mounting bar(B).
2. Place mounting bar (B) flush against ceiling at desired mounting location. Using outside
mounting bar holes as a guide, mark where pilot holes are to be drilled.
3. Inset two plastic anchors (D) into the pilot holes (for drywall ceiling).
4. Align outside mounting bar holes with plastic anchors (D) (If applicable). Secure mounting
bar (B) into place using wood screws (E).
5. If need adjusting length of fixture, loosen set screw (C) at the wire nut (F) and carefully
insert/pull the cord (G) into/from the canopy (H). Then, secure the set screw (C) at the desired
wire location.
6. Make an electrical connection by loosening the terminal screws on the terminal block (M)
and inserting the live, neutral and ground terminals.
7. Tighten terminal screws. Make sure there are no stray wires.
8. Raise canopy (H) to ceiling, allowing mounting screw (A) to protrude through openings in
canopy (H) and secure into place with cap nuts (T).
9. Install the shade (I) and support ring onto the socket and secure with screws or retaining ring,
whichever is applicable.
10. Install lamp (not supplied). (Please do not exceed the maximum capacity recommended on
the socket).
MOUNTING AND WIRING INSTRUCTIONS