32
31031 R1
Figure 13.
Wheel Over-Center Handle Positions
Engaged
Disengaged
2. Set and run the gas engine at approximately half throttle.
3. Refer to the controls shown in
Figure 14
–
Figure 16
.
Note
There are three different mover kit options available for the STX2 Series auger as shown in the
figures.
4. Before moving the auger into position:
•
Fully lower the auger.
•
Raise the intake end slightly off the ground to position the auger.
•
Raise the auger discharge end only for final positioning such as when next to a storage bin or grain truck.
Figure 14.
Mover Kit Controls — Heavy Duty Hydraulic Control
5. PLACEMENT
STX2 SERIES – PORTABLE GRAIN AUGER
