Westfalia 90 02 30, Оригинальное руководство пользователя

Страница: 13 / 18

9
Operation
Before first Use
Remove the mini jig saw and all accessories out of the packaging and check
all parts for damage in transit. Keep packaging materials out of reach of
children. There is risk of suffocation!
Intended Use
This tool is intended for delicate jigsaw operations in wood and plastic.
Attention: After 10 minutes of operation allow the saw to cool down for at
least 5 minutes.
Fitting/Changing the Saw Blade

Loosen the clamping screw (5) on the saw blade holder with the included
2.5 mm Hex key.

Insert the saw blade (6) into the slot of the saw blade holder. The saw
teeth facing forward.
Attention: The saw blade (6) must sit in the groove of the guide roller.

Retighten the clamping screw (5) using the Hex key.
Note: Replace the saw blade (6) as soon as its teeth are blunt and proper
sawing is increasingly difficult. Only sharp and undamaged saw blades make
an optimum cut and prevent the tool from being overloaded.
Fitting the Parallel Guide
The parallel guide (8) can be fixed on the left- or right hand side of the tool.

Loosen both locking screws on the insertion braces (7).

Push the parallel guide into the insertion slots under the braces (7).

Set the desired cut width. The value on the scale on the parallel guide (8)
and the outer edge of the insertion brace (8) must correspond.

Retighten the two locking screws.
Note: If you want to use the parallel guide for curved cuts, insert a nail through
the bottom hole, which is in line with the saw blade. Otherwise the diameter
will be incorrect.
Switching the Tool ON and OFF

Set the ON/OFF switch (1) to "I" to switch the jig saw on.

Set the ON/OFF switch (1) to "O" to switch the jig saw off.

The tool is intended for short-term operation S2 of max. 10 minutes (10
minutes of operation, 5 minutes cool-off).