Westfalia 90 02 30, Оригинальное руководство пользователя

Страница: 14 / 18

10
Operation
Setting the Cutting Angle

Undo the locking screw (3) using the included 3 mm hex key.

Adjust the cutting angle to 0°/15°/30°/45° with the aid of the markings on
the scale (4).

Retighten the locking screw (3) using the Hex key.

Cut a rest piece and check the cutting angle.
Setting the Stroke Rate

Use the speed control dial (1) to set the required stroke rate.

Set a higher stroke rate and use a coarse-toothed blade for soft materials.

Set a lower stroke rate and use a fine-toothed blade for hard materials.
Maintenance and Cleaning

Before undertaking any maintenance or cleaning work, disconnect the
power plug from the power mains.

Remove any dirt (e.g. sawdust). Clean the saw blade holder, if necessary,
with a brush or by blowing it out with compressed air.

Add a few drops of motor oil to the piston and the guide roller regularly
(after approx. 30 minutes of runtime).

Keep the ventilation openings clean and free from obstructions at all times.
Clean out the slots after each use with a stiff brush or compressed air.

Do not use water or any other liquid to clean the machine. Do not use
solvents, abrasives or aggressive chemicals to clean the machine.

Store the machine in a dry place and protect it from dirt. Store the machine
out of reach of children and persons in need of supervision.