Dokument: 1597en06.doc
Förf.: LT/JJo
Datum: 2017-11-30
Sida: 4 av 9
WESTERSTRAND URFABRIK AB
Box 133
Tel. 0506 48 000
Internet:
www.westerstrand.se
545 23 TÖREBODA
Fax. 0506 48 051
E-mail:
3. Check of motor before mounting of hands
At delivery the device is set to full hour (e.g 12.00). The red arrow (6) then points to 0-mark of the setting
plate (1).
1. Check that the arm of the micro switch (10) is in position shown as 10 B on the sketch above.
- If so, continue to 2.
- If not, (which means (10) is in the same position as 10B on the sketch) carry on as follows:
Turn wheel (2) clockwise or anti -clockwise until the arm of the micro switch enters the notch position 10 B
in the wheel underneath the curve (11).
2. Check that the pin (3) fit straight into the hole (4), which should be positioned straight under the pin (3),
when the P-arm (5) is pressed down. In this position the red arrow (6) should point straight to the 0-mark on
the graded disc. (1)
- If so , continue mounting the hands. ( see p.5.1 below)
- If not adjust as follows:
A.
Move the brass wheel (2) slightly anti-clockwise until pin (3) is just over hole (4)
B.
Press the P-arm (5) so the pin (3) enters hole (4) and keep it pressed down. This step releases the
synchronous motor.
C.
Turn the minute hand drive (9) anti-clockwise until the red arrow (6) points straight to 0-mark on the
setting plate.
D.
Release the ‘press down’ of the P-arm.
Proceed to mounting of hands p.5.1 (see below).
4. Mounting of hands.
1.
Mount the hour hand on the shaft with it´s needle point aiming straight to 12.
2.
Fasten the hour hand carefully.
3.
Mount the minute hand on the shaft wit it’s needle point aiming straight to 12.
4.
IMPORTANT!
There should be some space on the shaft between the minute- and hours hand.
5.
Fasten the minute hand carefully.
