Wesmar SS395, Руководство по установке и эксплуатации

Страница: 24 / 37

24
An extension cable, 25 ft (7.6 m)
#78.01070.0 is available if additional length is
needed.
7. Soundome with cable
The soundome cable is 15 ft (4.6 m) long.
Connect the soundome cable to the transmitter re-
ceiver unit. Extra cable should be coiled neatly and
tightly wrapped in place. Confirm there is enough
slack for hoist movement.
THIS COMPLETES THE INSTALLATION.
REFER TO PART 4, SONAR SYSTEM CHECK,
DC HOIST
2.5 Operational Checks
2.5.1 Lowering hoist first time
1. Check to make sure there is enough room beneth
the boat when the soundome goes down.
2. Unplug the hoist motor from the hoist cable.
3. In the wheelhouse push the hoist down on the
switch panel.
4. Plug the hoist motor back into the hoist cable
only enough so the motor runs.
5. Watch the motor as it travels down. It should
stop before the safety clamp comes in contact with
the packing gland. If it looks like the safety clamp
will hit the packing gland unplug the hoist motor.
Rotate the lead screw by hand so the clearance is
no less than .5 in (13 mm) above the packing gland.
Remove the bronze shear pin at the bottom of the
lead screw. Plug the motor back in. The motor will
run and stop. Replace the shear pin.
6. In the wheelhouse verify the red hoist light is on.
This light is a reminder that the hoist is down.
7. In the wheelhouse push the hoist switch up to
raise the soundome. In about 20 seconds the red
hoist lgiht should go out. When the light does go
out, check the position of the top hoist clamp. It
should be up and the motor has stopped running.
2.5.2 Check hoist travel distance
The hoist motor is calibrated at the factory for the
correct travel distance. Lower the hoist and check
Hoist Power Cable
Hoist Control Cable
Hoist Motor