5
M10
Washer (35)–2
M10 Split
Washer (59)–2
M10 Locknut
(33)–6
Pedal Arm Bolt Set (40)–2
M6 Locknut
(27)–4
M10 x 25mm
Patch Screw (22)–2
M10 x 75mm Carriage Bolt (34)–4
M10 x 68mm Button Bolt (48)–2
M6 x 38mm
Button Bolt (50)–4
M6 x 45mm Flat Head
Screw (36)–4
Wave Washer
(64)–2
M6 x 18mm
Screw (43)–4
1.
Identify the Front Stabilizer (10), which is nar-
rower than the Rear Stabilizer (not shown).
Have a second person lift the front of the Frame
(1).
Attach the Front Stabilizer (10) to the Frame (1)
with two M10 x 75mm Carriage Bolts (34) and
two M10 Locknuts (33).
10
34
1
1
33
To make assembly easier, read the
information at the top of this page.
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons.
Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials; do not dispose of the packing materials until assembly is completed.
In addition to the
included tool(s), assembly requires a Phillips screwdriver
, an adjustable wrench
,
and a rubber mallet
.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly.
Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
33
