10
7. Have a second person lift and hold the Frame
(67) until step 8 is completed.
Next, place the cylinder end of the Gas Spring
(1) near the bracket on the Base (101).
See the two small inset drawings. Using your fin-
gernail or the end of a screwdriver, press on the
end of the Gas Spring Pin (7) to loosen it from
the Gas Spring (1). Next, rotate the Gas Spring
Pin and pull it out of the Gas Spring.
Be careful
to avoid losing the Gas Spring Pin.
See the lower drawing.
Press the cylinder end
of the Gas Spring (1) onto the ball on the
bracket. Next, insert the end of the Gas Spring
Pin (7) through two of the small holes in the end
of the Gas Spring. Then, rotate the Gas Spring
Pin until it clips onto the Gas Spring.
1
7
1
7
7
101
67
Bracket
Cylinder
Bracket
7
7
8. Raise the Gas Spring (1) to a vertical position.
Remove the Gas Spring Pin (7) from the raised
end of the Gas Spring as described in step 7. If
necessary, rotate the Gas Spring to align the
end of the Gas Spring with the ball on the
bracket on the Frame (67).
Then, press the end of the Gas Spring (1) onto
the ball.
Note: It may be necessary to move
the Frame forward or backwards as you
press the Gas Spring onto the ball.
See the lower drawing.
Insert the Gas Spring
Pin (7) into the two indicated small holes in the
end of the Gas Spring (1) Then, rotate the Gas
Spring Pin until it clips onto the Gas Spring.
Note: Extra Gas Spring Pins are included.
Lower the Frame (67) to the floor.
7
1
Holes
7
1
8
67
Bracket
Holes
All manuals and user guides at all-guides.com
