Wen MM1215, Инструкция по эксплуатации

Страница: 18 / 36

2
3
4
1
CHANGING THE SAW BLADE
DANGER! Never try to use a blade larger than the stated
capacity of the saw. Do not use a blade thicker than 1.9mm.
It will prevent the blade screw from properly securing the
blade on the spindle. Install the suitable blade for your cut-
ting operation.
1. Unplug the tool from its power source.
2. Pull out the saw arm release bolt and let the saw arm
rest in the upper position. Use a Phillips-head screwdriver
(not included) to remove the blade guard bolt (Fig. A - 1)
that holds the blade guard plate in place. Raise the lower
blade guard (Fig. A - 2) and the blade guard plate so that
you can access the arbor hex bolt.
3. Firmly press down the saw spindle lock ( Fig. 13 - 2 ) be-
low the operating handle and hold it in. Use the included
6mm hex wrench to turn the arbor bolt clockwise and re-
move it (the bolt is left-hand threaded) (Fig. 13 - 3). Re-
move the washer, outer flange, and arbor insert. Make sure
the inner flange stays in place on the arbor.
4. Slowly remove the blade by pulling it out and down.
Clean the arbor bolt, washer, outer flange, and arbor insert.
ASSEMBLY & ADJUSTMENTS
5. Place the arbor insert onto the spindle. Place the new blade over the arbor insert.
IMPORTANT: Make sure the blade's rotation arrow points in the same direction as the rotation arrow on the upper
blade guard.
6. Lower the blade guard, making sure that the blade guard is properly lowered and covering the arbor bolt. Re-
install the blade guard screw. Make sure that the blade guard moves freely and covers the entirety of the blade.
7. Allow the lower blade guard to return back into position.
IMPORTANT: Carefully rotate the saw blade and make sure that it does not wobble. Lower the saw arm and check
that the blade does not contact the kerf board, with the saw at 0° and 45° bevel angles. Make sure the lower blade
guard operates properly before using the saw.
Fig. 13
18