Wen DT1516, Инструкция по эксплуатации

Страница: 16 / 24

16
The dethatcher / scarifier comes with two lawn blades with
two different functions. The dethatching / raking blade (Fig.
8 - 1) comes pre-assembled on the machine. The scarifier
blade (Fig. 8 - 2) is included inside the box and can be
changed out according to your application.
To remove the scarifier or dethatcher blade:
1. Unscrew the hex screws (Fig. 9 - 1) on the bottom of the
dethatcher / scarifier body.
2. Carefully remove the blade bracket and blade (Fig. 9 - 2).
When removing the dethatcher blade, wear safety gloves
and take care not to scrape yourself on the sharp tines.
Note that both blades may get hot during operation.
To install the scarifier or dethatcher blade:
1. Align the square end of the blade shaft with the square
hole of the output gear (Fig. 10).
2. Press the bearing on the blade into the blade bracket
slot. Secure the blade in place by reinstalling the blade
bracket and hex screws using the included hex wrench.
MAINTENANCE
WARNING! Make sure that the machine is OFF and disconnected from the power source before removing
or replacing the cutting devices.
WARNING! The tines are very sharp and become hot during use. Handle with care when removing or replac-
ing. Wear safety gloves when handling the tines to avoid burns and / or cuts.
REPLACING / CHANGING THE BLADE
Fig. 8
Fig. 10
2
Fig. 9
1
1
2