Wen 61731, Руководство пользователя, Страница: 14 / 20

OPERATION
3b.
For Multiple Firing Mode:
Pull the trigger and press down the safety bracket to drive a fastener. Release the safety bracket while holding
down on the trigger, reposition the nailer and engage the safety bracket again to drive the next nail. Double fir-
ing may occur if the safety bracket is engaged between shooting nails. So it is recommended to release the safety
bracket after driving each nail.
NOTE:
Unit may spark when nails are fired, this is normal.
WARNING:
Do not fire another nail over the position of the existing nail, as the nail may bounce
back and cause serious injury.
4. Regularly check the nail gauge window to see the load of fasteners in the magazine. Make sure to refill the
magazine before the fasteners run low. The anti-dry-fire mechanism engages at approximately 3 nails left in
magazine to protect the nailer from blank firing.
5. After operation, turn off the air compressor and depressurize the compressor according to the instructions
included with your compressor. Disconnect the air hose from the nailer. Remove the remaining nails from the
magazine.
SHOOTING NAILS (Fig. 10)
1. Check that the air supply is correctly connected to the tool
at the suitable pressure, and the fasteners have been properly
loaded into the magazine.
2. Hold the nailer upright on the workpiece and position the
safety bracket where the fastener will be driven (Fig. 10).
3a.
For Single Firing Mode:
Press down the safety bracket and pull the trigger to drive a
fastener. The nailer should be allowed to jump off the sur-
face at firing. Disengage the trigger and safety bracket, and
reposition the nailer between shooting multiple nails.
WARNING:
User must wear proper eye and hearing protection when operating this tool. Stay alert
and keep proper balance at all times. Keep your fingers AWAY from the trigger when not operating
the nailer to reduce the risk of unintended nail discharge.
WARNING:
Never attempt to drive a fastener into materials that are too hard, or at a steep angle, or
near the edge of the workpiece. The fastener can ricochet and cause serious personal injury.
WARNING:
Before each use, check the nailer, compressed air connections and air lines. If any
parts are missing or damaged, do not operate this tool until the parts are repaired and replaced. Fail-
ure to do so could possibly result in a serious personal injury.
Fig. 10
90°
14