Wella Visionair M50, Руководство по эксплуатации

Страница: 42 / 178

44
ENGLISH
5 Cleaning and changing air filter
Figure 9
5.2 Continued
5.2.2 Hairdryer dome
Damage to the appliance - do not use tools:
• Only undo / tighten the fastening screws 3 with a suitable coin.
Dismounting
1. Comply with the safety instructions in “Section 5.1” page 43.
2. Unscrew the four
fastening screws 3
with a suitable coin to the left
(anticlockwise) and lower the hairdryer dome
2
out of the appliance.
Cleaning
3. Only ever dry clean the airflow grille 4 and temperature sensor 5 with a
brush or use a vacuum cleaner with a brush attachment.
4. Clean appliance surfaces (underneath the hairdryer dome 2 ) and hairdryer
dome 2 with a soft cloth that has been slightly moistened in water with a
little washing-up liquid added and well wrung out beforehand.
Installation
5. Replace the hairdryer dome 2 and screw into place with the 4 fastening
screws 3 using a suitable coin to the right (clockwise).
6. Check that the 4 fastening screws 3 and the hairdryer dome 2 are securely
in place.
Figure 10
5.3 Changing air filter
Check the
air filter 2
at least every 4 weeks and change it, if necessary.
Dismounting
1. Comply with the safety instructions in “Section 5.1” page 43.
2. Press both
release mechanisms 1 in the direction of the filter cover with air
filter b until you hear a click and pull them slightly downward.
3. Detach the filter cover with air filter b at the front, and remove.
Changing filter
4. Take the air filter 2 out of the appliance and change it, if necessary.
5. Only ever clean the air grille 3 with a brush or use a vacuum cleaner with a
brush attachment.
6. Snugly fit a new air filter 2 in the filter cover b .
Installation
7. Fit the filter cover with air filter
b
at the front of the appliance and push it
upward.
8. Press both release mechanisms 1 in the direction of the ON/OFF switch a
until you hear a click into place.
9. Check that the filter cover with air filter b is securely in place.
NOTICE