WELDY WGW 300, Руководство по эксплуатации

Страница: 7 / 24

7
Set-up Upper Contour Roller Configurations:
Location:
The upper contour roller (#15, Figure 2) assembly is located above the heating wedge and is fixed to the bottom
of the nip arm assembly.
Note:
There are two types of springs, one that the roller axle mounts to and one that is used as a stiffener or “back
up spring”. There are also two mounting locations on the mount plate, one for the rear roller set (closest to the nip
rollers) and one for the front roller set (furthest from the nip rollers).
Removing-upper contour roller assembly:
• Remove screw from the end of the shaft that the material guide plate pivots on, then slide material guide off of
shaft and set aside.
• Remove the two Phillips head screws that attach the upper contour roller assembly mount plate to the nip arm
and remove contour assembly from the unit. You may need to move the heating wedge fore or aft for access
with screwdriver.
Figure 2
Front roller set
(furthest from the nip
rollers)
Rear roller set
(closest to the nip rollers)
Figure 3
6
11
15