WELDY WGW 300, Руководство по эксплуатации

Страница: 10 / 24

10
Power Up
Connect the WGW 300 power cord to power source making sure that the voltage is correct for the model of
welder you have.
Flip the main power toggle switch (#1, Figure 6) to the “on” position (up). The main power switch is located on
the right of the control box, below the front handle. After a 3 second delay, the temperature control unit (#5,
Figure 6) located on top of the control box should light up and display current wedge temperature.
Turn on the drive motor with the motor switch (#3, Figure 6), located on the top of the control box. It is
recommended that the drive motor remain on at all times while the welder is plugged in. This helps to eliminate
hot spots on the nip rollers and makes starting a weld quicker and easier.
Setting Wedge Temperature
• OMRON Controller (5 button style)
Temperature controller has a dual display. The current wedge temperature set point is displayed on the right side
of the display. The actual wedge temperature is displayed on the left side of the display.
To adjust the wedge temperature set point, press the up arrow button to increase the set point or the down arrow
button to decrease the set point. Flip the heating switch (#4, Figure 6) to the "on" position, heating start to work
immediately.
Setting Weld Speed
To set weld speed, use the knob directly (#3, Figure 6) located on top of control box, next to temperature control
unit.
Please refer the chart on the top of control box to get the correct speed value.
Welding Procedure
Figure 6
5
4
2
3
1