Weldtronic TM250C, Руководство по эксплуатации

Страница: 13 / 48

9
TitanMig AU 250C Manual_ Issue A 0415
CYLINDERS can explode if damaged.
Shielding gas cylinders contain gas under high pressure. If damaged, a cylinder can
explode. Since gas cylinders are normally part of the welding process, be sure to treat
them carefully.

Protect compressed gas cylinders from excessive heat, mechanical shocks, slag, open flames, sparks, and
arcs.

Install cylinders in an upright position by securing to a stationary support or cylinder rack to prevent falling
or tipping.

Keep cylinders away from any welding or other electrical circuits.

Never drape a welding torch over a gas cylinder.

Never allow a welding electrode to touch any cylinder.

Never weld on a pressurized cylinder - explosion will result.

Use only correct shielding gas cylinders, regulators, hoses, and fittings designed for the specific application:
maintain them and associated parts in good condition.

Turn face away from valve outlet when opening cylinder valve.

Keep protective cap in place over valve except when cylinder is in use or connected for us
FIRE OR EXPLOSION hazard.

Do not install or place unit on, over, or near combustible surfaces.

Do not install unit near flammables.

Do not overload building wiring — be sure power supply system is properly sized, rated,
and protected to handle this unit.
FALLING UNIT can cause injury.

Use lifting eye to lift unit only, NOT running gear, gas cylinders, or any other accessories.

Use equipment of adequate capacity to lift and support unit.

If using lift forks to move unit, be sure forks are long enough to extend beyond opposite
side of unit.
OVERUSE can cause OVERHEATING

Allow cooling period; follow rated duty cycle.

Reduce current or reduce duty cycle before starting to weld again.

Do not block or filter airflow to unit.