Welch Allyn Micro Tymp 2, Руководство по обслуживанию

Страница: 11 / 66

E KEYPAD ASSEMBLY
E 5. REPLACE MOTOR/PUMP ASSEMBLY.
FOLLOW INSTRUCTIONS IN SECTION C4 THROUGH C6 FOR MOTOR/
PUMP ASSEMBLY.
E 6. TEST HANDLE.
PERFORM FUNCTIONAL CHECKS TO ASSURE CORRECT OPERATION
OF REPLACEMENT SWITCHES.
NOTES:________________________________________________________________________
______________________________________________________________________________
F LCD ASSEMBLY
F 1. REMOVE LCD RETAINER.
FOLLOW STEPS E1 THROUGH E3 TO REMOVE LCD RETAINER.
F 2. REMOVE LCD MODULE.
LIFT OUT LCD MODULE.
REPLACE LCD ASSEMBLY
F 3. PLACE LCD ASSEMBLY INTO BACK HOUSING.
REMOVE PROTECTIVE FILM FROM BEZEL. RECORD LCD ID# ON DOCU-
MENTATION. ALIGN LCD ASSEMBLY WITH FLEX CIRCUIT CONNECTOR
ON RIGHT HAND SIDE THEN PLACE INTO HOUSING.
F 4. SECURE MODULE WITH RETAINER.
PLACE LCD MODULE RETAINER AND PLACE LATCH IN THE NOTCH AT
THE TOP OF THE BACK HOUSING. ALIGN TWO PINS ON UNDERSIDE
OF RETAINER WITH TWO ALIGNMENT HOLES OF KEYPAD PCB.
SECURE WITH TWO SCREWS.
F 5. REASSEMBLE HANDLE.
FOLLOW INSTRUCTIONS IN SECTION C 4 THROUGH C 6 AND
PERFORM FUNCTIONAL CHECKS.
END LCD ASSEMBLY REPLACEMENT
NOTES:________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
5