A
NORMAL MAINTENANCE :
BATTERY COVER, BATTERY, RECHARGING
BATTERY, RECYCLING THE USED BATTERY
A
1. REFER TO PAGE C-43 THROUGH C-47 OF MICROTYMP 2 OPERATING
INSTRUCTIONS FOR REPLACEMENT OF BATTERY PN72900.
WARNING: INSERT BATTERY ONLY AS SHOWN IN THE OWNERS
MANUAL. FAILURE TO OBSERVE CORRECT POLARITY COULD CAUSE
DAMAGE TO THE MICRO TYMP 2. WHEN IT IS NECESSARY TO RE-
PLACE THE BATTERY, USE ONLY A WELCH ALLYN PN72900 REPLACE-
MENT BATTERY. OTHER NON APPROVED BATTERIES MAY CAUSE
RISK OF FIRE OR PRODUCT FAILURE.
CAUTION: The battery must be removed if the MicroTymp 2 is to be stored
or placed anywhere other than in the Charging Stand (or connected to the
Charging Transformer) for more than one month. Failure to do this can
result in damage to BOTH the battery and the MicroTymp 2.
A
2. FOLLOW THIS PROCEDURE FOR DECIDING WHEN TO REPLACE THE NI-
CAD BATTERY IN A MICRO TYMP HANDLE: (AS ALWAYS, READ THE
CUSTOMER COMPLAINT FIRST.)
SCENARIO 1
If the unit FUNCTIONS, (the battery has held sufficient charge during
approximately two days transit) the battery meets requirements. No
corrective action is to be taken. However, it is good practice to put the
battery on charge for however long it is in your possession.
OR
SCENARIO 2 a
If the unit DOES NOT FUNCTION AND the battery is IN warranty, put in
a fully charged new battery (your test battery). If the unit functions, and
Low Battery symbol disappears, REPLACE THE BATTERY UNDER
WARRANTY. Install a fully charged BATTERY. Recycle the failed battery
per Welch Allyn’s recycling policy.
2 b
If the unit DOES NOT FUNCTION AND the battery is OUT of warranty,
put in a fully charged new battery (your test battery). If the unit functions,
sell a new battery. If the unit does not function, look for other problems
while charging the customer’s battery. Sell a new battery if customer’s
battery won’t ACCEPT AND HOLD a full charge.
NOTES:
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
1
Содержание Micro Tymp 2
