4
Microwave service manual – Model:
microMD UK
Installations
Installing
1. Empty the microwave oven and clean inside
it with a soft, damp cloth. Check for damage
such as misaligned door, damage around
the door or dents inside the cavity or on the
exterior.
2. Put the oven on a counter, table, or shelf that
is strong enough to hold the oven and the
food and utensils you put in it. (The control
panel side of the oven is the heavy side. Use
care when handling.)
3. Do not block the vent and the air intake
openings. Blocking vent or air intake
openings can cause damage to the oven
and poor cooking results.
Make sure the microwave oven legs are in
place to ensure proper air flow.
4. The oven should not be installed in any
area where heat and steam are generated,
because they may damage the electronic or
mechanical parts of the unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall
oven.
5. Use the microwave oven in an ambient
temperature less than 104°F (40°C).
6. Place the microwave oven on a sturdy and
flat surface at least 10 cm (4 inches) from the
wall.
7. Place the microwave oven as far away as
possible from TV, radio, computer, etc., to
prevent interference.
Important:
The wires in this mains lead are coloured
in accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
Earthing instructions
This microwave oven is designed to be used in
a fully earthed condition.
It is imperative, therefore, to make sure it is
properly earthed before servicing
Warning: This appliance
must be earthed
Before you begin, read the following instructions completely and carefully.
10cm
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
• The wire which is coloured green-and-yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the
earth symbol (X) or coloured green or green-
and-yellow.
• The wire which is coloured blue must be
connected to the terminal in the plug which is
marked with the letter N or coloured black.
• The wire which is coloured brown must be
connected to the terminal in the plug which is
marked with the letter L or coloured red.
