4.
INSTALLATION
Model #
Unit
Unit with
shipping box
MKEL40T
820 lbs.
890 lbs.
MKEL60T
870 lbs.
940 lbs.
MKEL80T
1,130 lbs.
1,200 lbs
.
MKEL100T
1,285 lbs.
1,355 lbs.
Model #
Unit
Unit with
shipping box
TMKEL40T
1,600 lbs.
1,670 lbs.
TMKEL60T
1,670 lbs.
1,740 lbs.
TMKEL80T
1,840 lbs.
1,910 lbs
.
TMKEL100T
2,150 lbs.
2,220 lbs.
APPROXIMATE WEIGHTS
GENERAL
Environment:
Insure gas and electrical supplies match rating plate.
Installation of the kettle must be accomplished by qualified
installation personnel working to all applicable local and
national codes.
This equipment is built to comply with applicable standards
for manufacturers. Included among those approval agencies
are: UL, NSF, ASME/N.Bd., CSA, ETL, and others. Many local
codes exist, and it is the responsibility of the owner/installer
to comply with these codes.
Observe all clearance requirements. Do not obstruct the flow
of combustion and ventilation air.
RECEIVING INSPECTION
Before unpacking visually inspect the unit for evidence of
damage during shipping.
If damage is noticed, do not unpack the unit, follow shipping
damage instructions.
SHIPPING DAMAGE INSTRUCTIONS
If shipping damage to the unit is discovered or suspected,
observe the following guidelines in preparing a shipping
damage claim.
1.
Write down a description of the damage or the reason for
suspecting damage as soon as it is discovered. This will
help in filling out the claim forms later.
2.
As soon as damage is discovered or suspected, notify
the carrier that delivered the shipment.
3.
Arrange for the carrier's representative to examine the
damage.
4.
Fill out all carrier claims forms and have the examining
carrier sign and date each form.
Unit is heavy use adequate help
or lifting equipment as needed.
1.
Carefully cut any straps from
container.
2.
Lift off carton.
3.
Inspect for hidden damage.
If found refer to “SHIPPING
DAMAGE INSTRUCTIONS”.
4.
Cut strap holding unit.
5.
Remove lag bolts from feet.
6.
Remove manual from kettle
pot. Write down the model #
and serial # of the unit onto
the front of this manual.
7.
Lift kettle off skid and move
kettle to its installation location.
8.
Discard packaging material
according to local and or state requirements.
VENTILATION
Operation of these units can produce significant levels of steam and
condensate, it is recommended they be installed under a ventilation
hood in a room which has provisions for adequate make up
air. Further information can be obtained by referring to the
U.S.A. National Fire Protection Associations NFPA96
regulations. These standards have also been adopted by the
National Building Code in Canada.
Operating Criteria
Acceptable Range
Ambient Air Temperature
15-40 degrees Celsius
Relative Humidity
0-80%
Altitude
0-3000 meters
Voltage
208-480, 3ph
Location
Inside building, under ventiltation hood
Model/
Serial#
UNCRATING
Caution
:
Straps under tension and will
snap when cut.
Carton may contain staples and
skid contains nails.
Use proper safety equipment
and precautions.
