User manual
TAXI-CHECK – V1.3
- 9
-
Step 10.
Since the system only has the ability to save tests as a completed set the
user is given the option of doing multiple tests (up to 10) for that set of
tests. To continue with another test select option 1(
Start next test
), this
will return the user to
step 1
allowing the next test to be setup. If that was
the final test for that set then select option 2(
End test set
), this will return
the user to the main screen. Test data can then be viewed by following
instruction shown in
section 3.6
.
3.2 Quick meter test
A quick meter test gives the user the ability to start a distance
measurement test without having to enter any pre test values. Only the
distance traveled is stored in the results field, meters over/under or
pass/fail cannot be calculated.
At the main screen or option 2 in the main menu, press the
ENTER
key.
Step 1.
If the vehicle is secured at this point then press
ENTER
to commence test.
If the roller bed cannot be found
error 1
will appear.
For information on errors go to
chapter 5
.
Step 2.
At this point the brakes are being released and the cab driver should
slowly start to increase the vehicles speed. Once the rollers have detected
wheel motion the screen will advance to
step 3
.
WHAT TO DO?
1. Start next test
2. End test set
PLEASE ENSURE
VEHICLE IS SECURED
PROPERLY!
ENTER TO PROCEED
BRAKE RELEASED
SLOWLY INCREASE
VEHICLE SPEED
40km/h MAX!
