weintek cMT-SVR, Руководство для стартапов

Страница: 5 / 21

V2.00
3
1.3 Connector pin designations
PIN#
Symbol COM1 RS-232
COM2 RS-485
COM3 RS-485
2W
4W
1 Data+ Data+
2 RxD Received Data
3 TxD Transmitted Data
4 Data- Data-
5 GND Ground
6 RX+ Data+ RX+
7 RX- Data- RX-
8 TX+ TX+
9 TX- TX-
1.4 USB host port and SD card slot
USB 2.0 full speed host interface supports barcode scanners and USB drive. While using external
hard drive, use external power supply. Do not use USB port to charge external device. You may use
SD card as an extension of storage
1.5 Ethernet port
The unit has two 10/100/1000M Gigabit Ethernet ports.
The LED indicators on the Ethernet port indicate:
Orange LED: LAN link status
Green LED: Active communication status
1.6 DIP switch
Each unit is equipped with a reset button and a set of DIP switches. When using the DIP switches to
change modes, the corresponding functions will be triggered.
When SW1 is turned ON and power the unit again, the IP setting is restored to default:
Ethernet 1: DHCP
Ethernet 2: 192.168.100.1
Note: Reboot cMT-SVR after adjusting DIP switches to start the corresponding mode. When restore
factory default, the project file and history data stored in the unit are all cleared.
SW1 SW2 Mode
OFF OFF Normal mode
ON OFF Restore Ethernet IP settings
OFF ON Boot loader mode
ON ON Restore factory default
cMT-SVR Startup Guide