background image

© weinor GmbH & Co. KG 

4 | EN 

© weinor GmbH & Co. KG 

EN | 5

and sun protection systems which are 

fi

 tted with weinor-radio 

receivers. Other use, or use going beyond this is not considered to 
be use for the intended purpose.
The hand-held transmitter is referred to in these instructions as the 
"unit".

Exclusion of liability

Weinor GmbH & CO. KG assumes no liability for personal injuries, 
property damage and 

fi

 nancial losses which arise from use other 

than mentioned above, modi

fi

 cations to the unit, improper use and 

failure to observe the operating instructions. Liability for material 
defects is excluded in such cases.

Scope of supply

BiEasy 5M hand-held radio transmitter (batteries included in the 
unit), wall bracket, 2 wall plugs, 2 screws.

Technical data

Name of unit

BiEasy 5M 

Operating voltage

3 V DC

Battery type

2 x LR06 (AA mignon)

IP Code

IP 20

Temperature range

0 to +55 °C

Radio frequency

867/868 MHz frequency band

Dimensions in mm (hand-held 
transmitter)

L 120 x W 51 x H 26

Weight in grams (including batteries).

120

There are regulations names for the USA, Canada, Australia and 
some countries in South America.

Radio frequency

915 MHz frequency band

 Operation

•  Use only in dry rooms.
•  The operating range of the system must remain visible during 

operation if one or more transmitters are used for controlling the 
system.

•  Keep control systems out of the reach of children and the 

disabled.

•  Dispose of used batteries properly.

Safety instructions for radio operation

Observe all safety instructions for radio operation.

Only use radio systems which are approved and can be operated 
without interference.
•  Radio systems must not be operated in areas where there is an 

increased risk of interference (e.g. hospitals, airports).

•  The remote control is only approved for units and systems for 

which any malfunction of the transmitter or receiver would not 
result in a risk for persons, animals or property, or if such a risk is 
covered by other safety equipment.

•  The operator has no protection whatsoever against interference 

by other telecommunication installations and local terminals (e.g. 
also from radio installations which are operated properly in the 
same frequency range).

•  The range of the radio signal is limited by legislation and the 

structural conditions.

Intended use

The BiEasy 5M is a multi-channel transmitter. It can be used for a 
bidirectionally datacommunication only. The hand-held transmitter 
should only be used for controlling roller shutter, Venetian blinds 

Safety instructions for radio operation

Exclusion of liability

0800 328 6250

www.samsondoors.co.uk

0800 328 6250

www.samsondoors.co.uk

Содержание BiEasy 1M











Отзывы: