weinor BiEasy 1M Скачать руководство пользователя страница 7

Страница: 7 / 10

12 | EN

EN | 13

If more than 10 bidirectional receivers are being programmed at the
same time, the transmitter channel in programming mode switches
to group mode. The group mode is indicated by fast

ashing with

pauses.
Programming in group mode is completed after a 2-minute pause or
pressing the

STOP

button for 6 seconds.

Note

A jogging mode for Venetian blinds for quickly reaching
receivers which are further away is not possible in a transmitter
channel with more than 10 programmed receivers.

Synchronous programming mode

For programming additional receivers to one transmitter at the same
time:
1. Press the

DOWN

button and the

programming button (rear of

unit) simultaneously (for 3 seconds) on a transmitter which has
already been programmed to the receivers. The status display

ashes. The receivers are now in programming mode.

2. Press the programming button

on the transmitter to be

programmed until the status display lights brie

y. The receivers

are now in programming mode (up/down movements).

3. Press the

button as soon as the blind starts moving in Open

direction (within no more than 1 second). The status display
lights brie

y. The blinds stop brie

y, start moving again, stop and

then move downwards.

4. Immediately (within no more than 1 second) after down travel

has started, press the

DOWN

button. The status display lights

brie

y. The blinds stop moving. The transmitter channel is

programmed.

Stopping programming mode in the transmitter

Press the

STOP

button for at least 6 seconds until the status display

lights orange.

Programming additional transmitters

Note

several receivers

are connected to the

same supply

line,

then all are simultaneously in programming mode for

approximately 5 minutes after the mains power is switched on.
If the

button on the transmitter is now pressed, all the

receivers start programming mode at the same time (up/down
movements). Randomly different intervals between up/down
movements cause the receivers to become offset against one
another. The longer programming is delayed, the greater the
offset will be.
The short up/down movements can be stopped by pressing
the

STOP

button brie

y on a transmitter which has already

been programmed. The programming mode in the receiver is
interrupted.
The transmitter can now be assigned without having to
disconnect individual receivers. If the blind moves in the wrong
direction, delete the transmitter and program it again.
(

→

see Deletion of transmitter)

For programming additional transmitters to one receiver:
1. Press the

DOWN

buttons and the programming button

(rear of unit) simultaneously (for 3 seconds) on a transmitter
which has already been programmed to the receiver. The status
display lights brie

y. The receiver is now in programming mode.

2. Press the programming button

on the transmitter to be

programmed until the status display lights brie

y. The receiver is

now in programming mode (up/down movements).