Document No.: CWL-URM-04A
|
Revision No.: 00.
|
Revision Date: 20.06.2022
Document No.: CWL-URM-04A
|
Revision No.: 00.
|
Revision Date: 20.06.2022
17
18
Problem
Possible Cause
Solution
The electrode patches
do not stick properly
to the skin.
The electrode patches
will undergo wear and
tear with regular use.
To improve their longevity, please
ensure that the skin on which they are
applied is dry, clean and free of lotions.
Put a few drops of water on the sticky
side of the pad and rub it on the
surface. This should improve its
stickiness.
Also ensure that the electrode patches
are stuck on the protective plastic after
use.
If the electrode patches still do not stick
then contact the authorized dealer to
get them replaced.
Weak sensation, even
on high setting.
Electrode patches
have been over-used,
or are dry.
Replace electrode patches
Sensation is too strong
Setting is too high
Press the button to decrease the setting
Sensation is too weak
Sensation is too low
Press the button to increase the setting
No sensation
Incorrect connection
Make sure that wires are connected
and are not damaged
Verify that the device is turned on
Make sure both electrode patches
are attached to the body
1.
2.
3.
14. EMC and Electrical standard requirement
Precautions with respect to electromagnetic compatibility are taken.
The Circulator must be installed and prepared to use as described in this manual.
Do not use accessories other than specified or sold by the manufacturer. Use of
replacement parts may lead to increased emission or decrease the immunity of the unit.
15. Notice to Users and/or Patients:
Any serious incident that has occurred in relation to the device, should be REPORTED to
the Manufacturer & the Competent Authority.
