WeiderPro 831.14923.1, Руководство пользователя

Страница: 19 / 48

19
27. Route the Low Cable (43) over a Pulley (69) and
through the indicated bracket on the Base (1) as
shown.
Attach the Pulley (69) and a Cable Trap (71) to
the bracket on the Base (1) with an M10 x 47mm
Bolt (91) and an M10 Locknut (74).
Make sure
that the Cable Trap is oriented to hold the
Low Cable in the groove of the Pulley.
26. Route the Low Cable (43) over a Pulley (69).
Attach the Pulley (69) and a Cable Trap (71)
between the Press Arms (17, 18) with an M10
x 125mm Bolt (83) and an M10 Washer (88).
Make sure that the Cable Trap is oriented
to hold the Low Cable in the groove of the
Pulley.
Note: Another Pulley (not shown) will be
attached with the same M10 x 125mm Bolt (83)
in step 28.
26
27
43
43
74
69
83
17
18
69
71
88
91
71
1
28. Route the Low Cable (43) upward between the
Press Arms (17, 18) and over a Pulley (69) as
shown.
Partially pull out the indicated M10 x 125mm
Bolt (83) until you can hold the Pulley (69) and
a Cable Trap (71) between the Press Arms
(17, 18).
Then, fully insert the M10 x 125mm Bolt (83)
and tighten an M10 Locknut (74) and an M10
Washer (88) onto it.
Make sure that the Cable
Trap (71) is oriented to hold the Low Cable in
the groove of the Pulley (69).
Then, route the Low Cable (43) through the indi-
cated side of the Upright (5).
Note: You will  nish routing the Low Cable (43)
in later steps.
28
69
83
18
71
17
5 43
88
74