10
8. Orient the Backrest Tubes (5) and the Backrest
(6) as shown.
Attach the Backrest Tubes (5) to the Backrest (6)
with four M6 x 38mm Screws (30) and four M6
Washers (26); do not tighten the Screws yet.
9. Insert the Backrest Support (7) into a set of
holes in the Uprights (1). Rotate the Backrest
Support to the locked position, with the locking
pin wrapped around the left Upright.
Apply grease to an M10 x 137mm Bolt (36).
Attach the Backrest Tubes (5) to the welded
tube on the Frame (2) with the M10 x 137mm
Bolt (36), two M10 Washers (34), and an M10
Locknut (33). Do not overtighten the Locknut;
the Backrest Tubes must pivot easily.
See steps 2–5. Tighten the M8 Locknuts (17).
See step 8. Tighten the M6 x 38mm
Screws (30).
10. Attach the Seat (11) to the Frame (2) with four
M6 x 16mm Screws (29).
8
5
30
26
26
Holes
30
6
9
Grease
34
5
36
7
1
2
Welded
Tube
1
Locking
Pin
33
34
10
11
29
2
Содержание 256 29829.1
Страница 17: ...17 NOTES...