Weider Pro 8000, Руководство пользователя

Страница: 19 / 44

19
48. Set an M12 Washer (129) on top of the Short
Weight Tube (123). Thread an M12 Nut (128) all
the way onto the Leg Lever Cable (70).
Thread the Leg Lever Cable (70) into the Short
Weight Tube (123). Tighten the M12 Nut (128)
against the M12 Washer (129).
49. Locate the Right Stack Cable (68). Attach the
Cable to the Left Top Frame (8) with an M8 x
80mm Bolt (94), an M8 Washer (117), and an M8
Nylon Locknut (115). Make sure the flat edge of
the Cable is against the Upright.
50. Wrap the Right Stack Cable (68) under a 90mm
Pulley (39). Attach the Pulley, a Small Cable Trap
(48), and two Half Finger Guards (42) to the
upper hole in the indicated “U”-bracket (50) with
an M10 x 52mm Bolt (102) and an M10 Nylon
Locknut (114). Make sure the Cable Trap is ori-
ented to hold the Cable in the groove of the
Pulley.
51. Wrap the Right Stack Cable (68) over a “V”-pulley
(40). Attach the “V”-pulley and a Cable Trap (49)
to the Left Top Frame (8) with an M10 x 55mm
Bolt (137) and an M10 Nylon Locknut (114).
Make sure the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
48
70
128
129
123
49
94
68
117
115
8
50
50
42
48
102
114
8
114
42
68
39
51
68
40
49
137
47. Route the Leg Lever Cable (70) over a 90mm
Pulley (39) and down through the Right Top
Frame (7). Attach the Pulley inside the Top Frame
with an M10 x 80mm Bolt (111), two M10
Washers (116), two 19mm Spacers (77), and an
M10 Nylon Locknut (114).
47
70
116
116
111
114
77
77
39
7
Flat
Edge