7
4.
Press a 2 1/2” Square Inner Cap (33) into the lower
end of the Right Upright (9).
Attach the Right Base (7) to the Right Upright (9) with
two M8 x 75mm Bolts (48), the Support Plate (28)
and two M8 Nylon Locknuts (40). Do not tighten the
Nylon Locknuts yet.
Make sure the Support Plate (28) is oriented as
shown in the drawing.
Tighten the Bolts (19) used in steps 1 to 4 now.
48
40
7
33
28
9
4
3.
Identify the Left Upright by (8) locating the welded
nut. The Left Upright must be oriented as shown
in the drawing. Press a 2 1/2” Square Inner Cap (33)
into the lower end of the Left Upright. Press a 2”
Square Inner Cap (29) into the lower end of the
Storage Post (27).
Attach the Left Base (6) and the Storage Post (27) to
the Left Upright (8) with two M8 x 75mm Bolts (48)
and two M8 Nylon Locknuts (40).
Do not tighten the Nylon Locknuts yet.
3
29
33
27
8
Welded Nut
6
48
40
5.
Press an Upright Bushing (60) into the top of each
Upright (8, 9).
Slide a Weight Rest (11) into the Left Upright (8).
Align one of the holes in the Weight Rest with the
hole in the Upright. Insert a Long Adjustment Knob
(25) through the Upright and the Weight Rest. Tighten
the Knob into the welded nut.
Insert the other Weight Rest into the Right Upright (9)
in the same manner. Both Weight Rests must be
set at the same height.
5
11
60
8
Welded Nut
11
25
6.
Press a 1 1/4” Square Inner Cap (34) into each end
of the Adjustment Tube (12).
Insert the Adjustment Tube (12) into one set of adjust-
ment brackets (C) on the Uprights (8, 9).
Make sure the Adjustment Tube is oriented as
shown and that the pins on the Tube are fully
inserted into the slots in the adjustment brackets.
Tighten the Locknuts used in steps 1 to 4 now.
6
12
C
8
Pin
Pin
9
34
34